Publicidad
Idiomas disponibles
Idiomas disponibles
Initial startup
Unpacking and unloading the vehicle
DANGER
Risk of injury, risk of damage
The vehicle is not approved for crane loading.
Do not use a forklift to unload/load the vehicle.
The packaging material (plastic bags, polystyrene, etc.) is a po-
tential source of danger and must be kept out of the reach of chil-
dren.
Unpack the vehicle carefully and do not use any tools that could
damage the vehicle. After unpacking, check that the vehicle is
complete and in working order. If not, contact Customer Service
Observe the instructions for pushing/towing the vehicle in a later
chapter.
Observe the vehicle weight when loading!
Net weight (transport weight)
Pushing/towing the vehicle (moving it without self-
propulsion)
Towing eye
1
● To tow, attach the towing eye to the front of the vehicle.
ATTENTION
Risk of damage!
The front towing eye must not be used for towing trailers or ob-
jects.
The magnetic brake on the engine must be opened before the ve-
hicle can be pushed/towed.
1. Pull the brake lever outwards
2. Lock/block the brake lever with a wedge or similar.
3. Pushing the device
After moving the vehicle, remove the blockage so that the mag-
netic brake works again as usual.
2525 kg
1. Cut the cable tape.
2. Remove the red safety clip.
3. Keep the safety clip, it is needed when transporting the device.
● Before initial start-up, read the operating instructions and ob-
● Park the device on a level surface and always secure it against
● Always remove the ignition key when leaving the vehicle.
Risk of injury!
Side brushes as well as brushes in the brush head and scrubbing
deck can rotate unintentionally.
Always switch off the device and remove the ignition key when
working in this area.
Never reach into the brush head when the vehicle is operating.
● Check the battery charge level and recharge the battery if nec-
● Check the hydraulic oil level.
● Empty the waste container.
● Empty the waste water tank.
● Fill the fresh water tank if necessary.
● Check the brush for wear and tear and damage.
● Check the suction lip of the suction bar for wear and tear and
● Check/clean the water and suction system.
● Check that the control elements are fully functional.
● Check the device for damage.
● Clean the dust filter with the filter cleaner button.
Note
For a description, see chapter "Care and maintenance".
English
Removing the transport lock from the suction bar
See chapter "Securing the vehicle".
General notes
serve the safety instructions contained therein.
rolling away (lock the parking brake).
CAUTION
Daily before the start of operations
essary.
damage.
33
Publicidad
