Publicidad
Idiomas disponibles
Idiomas disponibles
Eco button (energy-saving mode):
● The brush speed is reduced.
● The power of the suction turbine is reduced.
● The water quantity is reduced.
● The battery runtime is extended.
For cleaning tasks with normal contamination, set the turn switch
to ECO mode.
Filling the fresh water tank
Fresh water tank
1
Fresh water tank cap
2
Filling level display
3
5. Open the fresh water tank cap.
6. Fill the fresh water tank with fresh water (maximum 50 °C).
7. Add detergent. Observe the dosage notes.
8. Remove the fresh water tank cap.
Recommended detergents
ATTENTION
Risk of damage!
Various additives in detergents can cause damage to lines, seals
or the tank.
Only use the detergents recommended by the manufacturer and
observe the application, disposal and warning instructions of the
detergent manufacturers. More information about detergents can
be found in the data sheet (available from Kärcher) or in the notes
on the detergent container.
Only use detergents free of solvents, salt and hydrofluoric acid.
Do not use strong foaming detergents
Application
Maintenance cleaning of all water-resistant
floors
Maintenance cleaning of polished hard
surfaces (e.g. granite)
Maintenance cleaning and basic cleaning
of industrial floors
Maintenance cleaning and basic cleaning
of fine stone tiles
Maintenance cleaning of tiles in sanitary
areas
Coating removal on all alkaline-resistant
floors (e.g. PVC)
Opening and closing the waste container flap
The hydraulics must be switched on to open and close the flap.
Eco mode
Detergent
RM 745, RM 746
RM 755 ES
RM 69 ASF
RM 753
RM 751
RM 752
Note
It is recommended to open the flap of the waste container during
sweeping.
It is recommended to close the flap of the waste container during
wet cleaning.
● To open, press the operating lever, the display changes from
red to green
● To close, press the control lever again, the display changes
from green to red.
Due to the freshly mopped floor, place a clearly visible warning
sign warning for the risk of slipping.
Brush contact pressure rotary switch
1
Scrubbing deck water dosage
2
Brush head water dosage
3
1. Operate the control lever and switch on the hydraulics.
2. Set the cleaning mode function switch to wet cleaning.
The suction bar is lowered and the suction turbine starts.
3. Switch on the water pump.
4. Select the water dosage for the scrubbing deck and brushes.
5. In necessary, adjust the brush contact pressure.
a Use the turn switch to select the brush contact pressure be-
tween settings 1 (ECO), 2 (MEDIUM) and 3 (HARD).
6. Select the performance class (ECO or normal mode).
7. Release the parking brake.
8. Start the wet cleaning.
1. Stop the vehicle.
2. Turn the cleaning mode function switch to "Off" (centre posi-
tion).
The brushes lift up.
3. Switch off the water pump.
4. Switch off hydraulics.
The brushes stand still.
English
Starting the wet cleaning
Ending wet cleaning
35
Publicidad
