Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
WARNING! Only perform the steps described within these instructions. All further inspection,
maintenance and repair work must be performed by an authorized service centre or a similarly qualified
specialist if you cannot solve the problem yourself. Suspected malfunctions are often due to causes that
the users can fix themselves. Therefore check the product using this section. In most cases the problem
can be solved quickly.
Problem
Appliance won't start
Intermittent operation
Cutter bar becomes hot
sawing is having
difficulties running,
chain jumps off
Chain gets hot,
smoke develops
while sawing, the
rail changes color
Bad cutting
Note: if your device does not operate correctly after these
DISPOSAL
To help the environment, please dispose of the product properly when it has reached the end of
its useful life and not in the household waste. Information on collection points and their opening
hours can be obtained from your local authority
Environmental damage through incorrect disposal of the batteries / rechargeable batteries.
Remove the battery pack from the product before disposal. Batteries /rechargeable batteries may
not be disposed of with the usual domestic waste. They may contain toxic heavy metals and are
subject to hazardous waste treatment rules and regulations. Please dispose of batteries according
to the relevant local requirements
Possible cause
B
Battery pack discharged
a
Battery pack not inserted
Safety
switch
not
properly
On/Off
switch
defective
Internal loose contact
On/Off switch defective
Cutter bar is blunt
Cutter bar is notched
Too much friction due to lack of
lubrication
Insufficient chain tension
Too little chain oil
Saw chain / cutter bar /
3-tooth blade dull
Insufficient chain tension
Spool is empty
Bad cutting technique
Battery pack not fully charged
Corrective action
Recharge battery pack
Insert battery pack
pressed
Turn on (see "Operation")
or
motor
Send in to Service Centre for repair
Send in to Service Centre for repair
Have the safety cutter bar sharpened or
replaced (Service Centre)
Have the safety cutter bar checked or
replaced (Service Centre)
Oil the Cutter bar
Check the chain tension
Check the oil level and top of chain oil if
necessary, check the oil automatic on
and clean the oil drainage duct as
needed, or arrange for repair by Service
Centre.
Sharpen or replace
Check the chain tension
Replace the spool
See ("Working with the hedge trimmer")
Recharge battery
check, please contact the Service Center.
175
EN
EN
Publicidad
