Publicidad
Idiomas disponibles
Idiomas disponibles
Machine
documentation
Expectations for
information in
this manual
CALIFORNIA
Proposition 65
Warning
Laws pertaining
to spark
arresters
Manufacturer's
approval
VIBRATORY PLATE
•
From this point forward, this document will refer to ENAR.
Keep a copy of the Operator's Manual with the machine at all times.
•
If you are missing any of these documents, please ENAR to order a replacement
or visit www.enargroup.com.
•
When ordering parts or requesting service information, be prepared to provide the
machine model number, item number, revision number, and serial number.
•
This manual provides information and procedures to safely operate and maintain
the above ENAR model(s). For your own safety and to reduce the risk of injury,
carefully read, understand, and observe all instructions described in this manual.
•
ENAR expressly reserves the right to make technical modifications, even without
notice, which improve the performance or safety standards of its machines.
•
The information contained in this manual is based on machines manufactured up
until the time of publication. ENAR reserves the right to change any portion of this
information without notice.
•
The illustrations, parts, and procedures in this manual refer to ENAR factory-
installed components. Your machine may vary depending on the requirements of
your specific region.
Combustion exhaust, some of its constituents, and certain vehicle components contain or
emit chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm.
NOTICE: State Health Safety Codes and Public Resources Codes specify that in certain
locations spark arresters be used on internal combustion engines that use hydrocarbon
fuels. A spark arrester is a device designed to prevent accidental dis- charge of sparks or
flames from the engine exhaust. Spark arresters are qualified and rated by the United
States Forest Service for this purpose. In order to comply with local laws regarding spark
arresters, consult the engine distributor or the local Health and Safety Administrator.
This manual contains references to approved parts, attachments, and modifica- tions. The
following definitions apply:
•
Approved parts or attachments are those either manufactured or provided by
ENAR.
•
Approved modifications are those performed by an authorized ENAR service
center according to written instructions published by ENAR.
•
Unapproved parts, attachments, and modifications are those that do not meet
the approved criteria.
Unapproved parts, attachments, or modifications may have the following conse- quences:
•
Serious injury hazards to the operator and persons in the work area.
•
Permanent damage to the machine which will not be covered under warranty.
Contact your ENAR dealer immediately if you have questions about approved or
unapproved parts, attachments, or modifications.
en
ZEN-L
3
Publicidad
