Publicidad
Idiomas disponibles
Idiomas disponibles
6.7 SERVICING THE DRIVE BELT
Check
Procedure
en
Result
24
ZEN-L
On new machines or after installing a new belt, check the belt tension after first 20 hours
of operation. Check and adjust the belt every 50 hours thereafter.
Perform the procedure below to service the drive belt.
1.
Loosen the two screws (a) on the beltguard, then remove the beltguard, keeping
the screw assemblies captured on the beltguard.
2.
Remove the 4 x M6 nuts (b) on the clutch.
3.
Remove the clutch cover (c).
4.
Replace the belt (d) manually.
5.
Assemble the clutch cover (c).
6.
Put the 4 x M6 (b) nuts manually , then rotate the clutch position and make one nut
on the bottom position. Fix the bottom nut , then rotate another nut to the bottom
and fix the nut one by one.
7.
Set the 4 x M6 (b) nuts torque to 10NM.
8.
Assemble the beltguard, then fix the two M8 screws (a). Set the screws' torque to
10 Nm.
The drive belt has now been changed.
VIBRATORY PLATE
Publicidad
