ENAR ZEN-L 12 Manual De Operación página 51

5.6 STARTING THE MACHINE
Procedure
5.7 STOPPING THE MACHINE
Procedure
VIBRATORY PLATE
Perform the procedure below to start the engine.
Turn the fuel cock to the "ON" (OPEN) position (a1).
1.
Note: If the engine is cold, move the choke lever to close position (b1). If the engine is hot,
set the choke to open position (b2).
2. Move the governor lever to left a little (c1).
Turn the engine switch to "ON" position. (d1).
3.
4. Pull the starter rope (e).
Note: Don't allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter..
Preheat the engine and push back the choke lever to the "OPEN" position (f1).
5.
6. Move the throttle lever to proper position to make the gasoline engine run at required
velocity. (g1).
Perform the following procedure to stop the machine.
1. Reduce the engine rpm to idle by moving the throttle completely to the left (g).
2. Turn engine start switch to the OFF position (d2).
3. Close the fuel valve by moving the lever to the left (a2).
en
ZEN-L 17