Clutch Adjustment - SWM SILVER VASE Manual Uso Y Mantenimiento

CLUTCH ADJUSTMENT

The clutch is adjusted by stretching the cable using
the adjusting unit positioned on the handlebar.
As a rule it is sufficient to operate on the handlebar
register to restore the clearance due to the flexible
transmission stretch.
The control lever must always have a free play (C)
(about 3 mm - 0.11 in.) before starting to disengage
the clutch. To adjust this play, loosen the lock nut
(2) and act on the adjuster (3) after removing the
rubber cap (1); turning the adjuster in the direction
indicated by arrow A, the play (C) is reduced, while
turning it in the direction indicated by arrow B, the
play is increased.
The adjustment can be also effected with tightener
(4) set on the right of the frame. Take care to tighten
properly the lock nut. If the clutch slips under load
or drags in disengaged position after play has been
adjusted, it must be taken apart for inspection.
For this operation apply to a Dealer.
EN - 42
3 mm
0.11 in.
1
B
2
A
3
4
C