Removing The Rear Wheel - SWM SILVER VASE Manual Uso Y Mantenimiento

REMOVING THE REAR WHEEL

(SILVER VASE / GRAN TURISMO)
Position the motorcycle in such a way that the rear
wheel is lifted from the ground.
Unscrew the nut (1) of the wheel pin (2) and remove
the latter.
Extract the complete rear wheel, keeping the spac-
ers located at the hub sides.
For refitting, operate in reverse order from removal
fitting the brake disc in the calliper.
- Fit the wheel in the rear fork taking care to cor-
rectly fit the brake disc in the calliper.
- Fit the pin (2).
- Screw on the nut (1) without tightening it.
- Tension the chain using the tensioners (3) as de-
scribed in the relative paragraph.
- Tighten the nut (1) and the nut of the tensioners
(3).
Note*: Do not operate the rear brake pedal when
the wheel has been removed; this causes the cal-
liper pistons to move outwards.
After removal, lay down the wheel with brake disc
on top.
After reassembly, depress the brake pedal until the
pads are against the brake disc.
EN - 50
1
3
2
3