Gran Milano; Silver Vase / Gran Turismo - SWM SILVER VASE Manual Uso Y Mantenimiento

REASSEMBLING THE FRONT WHEEL

(SILVER VASE / GRAN TURISMO)

- Position the wheel between the legs, fit the speed-
ometer transmission (1) so that it correctly fits
into place with the wheel hub, then fit the brake
disc in the calliper checking that it correctly fits
into place.
- Fit the previously greased wheel pin (2) from the
right-hand side and screw it into place (50 Nm -
5.09 Kgm - 36.87 ft/lb).
- Now, pump for a while, pushing the handlebar
downwards until you are sure that the fork legs
are perfectly aligned.
- Lock: the screws (3) on the R.H. leg (10,4 Nm - 1,06
Kgm - 7.67 ft/lb).
SILVER VASE / GRAN TURISMO
1
EN - 48
Note*: After refitting the wheel, operate the brake
control lever until the pads touch the disc.
3
2
SILVER VASE / GRAN TURISMO
REMOVING THE FRONT WHEEL (GRAN MILANO)
Position the motorcycle in such a way that the front
wheel is lifted from the ground.
Remove the two screws (1) and the brake calliper (2).
Loosen the bolts (3) holding the wheel axle (4) to the
front fork mounts. Hold the head of the wheel axle
in place, and unscrew the bolt (5) on the opposite
side; draw the wheel axle out.
Note*: Do not operate the front brake lever when
the wheel has been removed; this causes the calliper
pistons to move outwards. After removal, lay down
the wheel with brake disc on top.

GRAN MILANO

2
3
4
1
5
3