Headlight Adjustment - SWM SILVER VASE Manual Uso Y Mantenimiento

TURNING INDICATOR BULB REPLACEMENT
10W bulb.
- Undo the screw (1) and remove the lens (2).
- Remove the bulb (3) by pushing and turning it an-
ticlockwise.
- Fit a new bulb in the bulb holder, pushing and turn-
ing it clockwise to lock it into place.
- Refit the lens (2) and tighten the screw (1) without
forcing.
2
1

HEADLIGHT ADJUSTMENT

When checking the proper aiming of the headlight
beam: inflate tyres at the right pressure, have a
person sit astride the motorcycle and set the mo-
torcycle perpendicular to its longitudinal axis
at 33 ft from a wall or screen. Then trace a hori-
zontal line at the height of headlight centre and a
vertical one, in line with vehicle longitudinal axis.
If possible, execute this operation in a shaded place.
When the low beam is on, the upper edge between
dark and lit zone should be at 9/10th of headlight
centre from ground.
3
Beam height can be adjusted as follows:
- Loosen the two screws (1).
- Adjust the position of the headlight (2) and then
tighten the screws (1).
9
10 X
10m
2
1
X
EN - 63