Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATIONAL INSTRUCTIONS
SETTINGS PAGE
This control panel has the following configurable parameters.
1) Equipment Model: Bicycle (bici)->Elliptical(EliP);
2)Total Distance;
3)Total Time;
4)Firmware Version.
Press and hold the START / ZERO and START / START buttons simultaneously for 3
seconds until the first Parameter (bici -> EliP) appears in the SPEED window, press
or
(BUTTONS 8 and 9) to set the equipment model and press START / ENTER
▲
▼
(BUTTON 10) to confirm and select the next parameter.
The next step will show the total distance (accumulated distance or odometer) in the
distance window. Press START / ENTER (BUTTON 10) to select the next parameter.
The next step will show the total time (accumulated hours or stopwatch) in the weather
window. Press START / ENTER (KEY 10) and select the next parameter.
The next step will display the firmware version in the Distance window. Press START /
ENTER to finish
Total time and distance
Total Time: 9999 hours -> 0001 = 1 hour
Total Distance: 9999km x 10 -> 0001 = 10 km
LOAD SYSTEM
The load of the equipment is intended to make the movement of the exercise lighter or
heavier. The larger the load, the heavier it will be. The lower the load, the lighter it will
be. The load can be adjusted according to the user's level of training. In conjunction with
the load selector, the rotation also influences the desired load, the higher the execution
speed of the exercise movement, the load will increase proportionally.
LOAD SELECTION
To select the desired load simply press the + / - buttons on
the handlebar in front of the electronics module. In the
electronic module there are also the + / buttons to also
increase or decrease the load of the equipment.
48
Publicidad
