Publicidad
Idiomas disponibles
Idiomas disponibles
Selecting the battery operation limitations
N.B.: the parameter is visible only if par.
There is no limitation for the commands when the battery voltage drops under the selected threshold. An error alert may
be activated via the COR output (if parameters
When the battery voltage drops under the threshold selected with par.
commands and does not perform closing.
When the battery voltage drops under the threshold selected with par.
automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands even if the ORO input is active and if the parameter is
When the battery voltage drops to the threshold selected with par.
automatically closes the gate and accepts only one opening command
Selection of the battery type and consumption reduction
NOTE: An INCORRECT setting of this parameter, when there is no mains voltage, blocks the functions and the display
shows the message
(if set to
Battery 24V
(2x12V
) with B71/BCHP. Acceleration/deceleration/speed reduction enabled, to increase the battery life.
Battery 36V
(3x12V
to increase the battery life.
Battery 36V
(3x12V
consumption.
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
P1
P2
x4 s
• The default factory settings have now been restored.
Note:
version appears on the display, press and hold down the
N.B.: The values shown in the table are indicative only.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed.
Example:
x100 = 1.234.500 manoeuvres.
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvre hours.
Example:
= 123 hours.
is different than
and
are adequately set).
or
and the battery is 2x12V
Warning! Restoring default settings cancels all settings made previously
except for parameter
,
are suitable for the installation.
• Press and hold the PLUS + and MINUS - button until the unit switches on.
• The display flashes after 4 s
(UP ARROW) and
Example:
to
multiplied by 100.
to
.
, the control unit accepts only opening
, after a 5 s pre-flashing, the control unit
.
the control unit, after a prelamping of 5s,
) or an error alert
.
,
,
: after restore, check that all parameters
.
(DOWN ARROW) buttons for 4s.
to
.
71
Publicidad
