Publicidad
Idiomas disponibles
Idiomas disponibles
12
Special parameters for High Speed series
The High Speed series (/HS) is a family of digital Brushless high speed sliding motor units for sliding gates
weighing up to 1000 kg ou 1600 kg (TW110/1000/HS - TW110/1600/HS) and dedicated exclusively to
residential applications.
High Speed technology makes it possible for the automation system to operate 100% faster than a
conventional system, and allows independent management of speed, acceleration, deceleration and the safety devices
used in the system.
Note: As the mechanics of the gate is unknown, to guarantee the maximum safety of the installation, we
recommended to use sensitive edges.
The additional parameters for enabling High Speed technology are indicated as follows.
Selecting automation system model
ATTENTION! The value of parameter
NOTE: in the case of resetting to the standard factory parameters, the value of the parameter is not changed.
TW110/2000
TW110/1000/HS
TW110/1600/HS
TW110/1200/R
Setting deceleration during opening
Setting deceleration during closing
= the gate decelerates near the mechanical stop/limit switch ...
stop/limit switch.
Setting start acceleration during opening
Setting start acceleration during closing
= the gate accelerates rapidly at start of manoeuvre ...
manoeuvre.
Setting opening speed
N.B.:
Setting closure speed
N.B.:
= 6 m/min ...
N.B.: to set the constant speed deceleration space, see parameters
is set at the factory to select the motor model (
= maximum speed.
= the gate decelerates long before the mechanical
= the gate accelerates slowly and progressively at start of
and
on chapter 12.
or
, see table below). If
73
Publicidad
