Kärcher B 110 R Manual Del Usuario página 18

* Filling system
1
Fresh water tank cap with fresh water filter
2
Coarse dirt filter
3
Waste water tank cap
4
Control panel
5
Squeegee blade adjustment wheel (D cleaning
6
head only)
Brush replacement pedal (D cleaning head only)
7
Steering wheel
8
Squeegee blade
9
Brush replacement handle (R cleaning head only)
10
Sidelight
11
Coarse dirt container (only with R cleaning head)
12
Detergent canister
13
Type plate
14
Detergent suction hose
15
Battery
16
* Internal charger
17
Battery connector (with external charger)
18
Charger mains cable (with internal charger)
Storage area for "Homebase Box" cleaning set
19
* Warning light
20
Seat
21
Waste water tank latch
22
Seat adjustment lever
23
Fresh water tank filling hole
24
Hose holder
25
Daytime running light
26
Accelerator pedal
27
* Side scrubbing deck
28
* Water connection for dirty water tank rinsing sys-
29
tem
Waste water tank lid support
30
Float
31
Fluff filter
32
Storage for suction bar
33
Waste water tank drain hose with dosing unit
34
Waste water tank
35
* Mop holder
36
Suction hose
37
Suction bar clamping lever
38
Waste water tank cap
39
Suction bar
40
Cleaning head
41
Fresh water filling level indicator
42
Fresh water tank
43
* optional
Colour coding
● Control elements for the cleaning process are yel-
low.
● Control elements for maintenance and servicing are
light grey.
18
Control panel
* Side scrubbing deck switch
1
Horn
2
Travel direction switch
3
Program switch
4
Intelligent Key
5
Display
6
Info button
7
Safety switch
8
Program switch
OFF
1
Device is switched off.
TRANSPORT MODE
2
Drive to the operating location.
ECO MODE
3
Clean the floor wet (with a reduced amount of water
and a reduced brush speed) and vacuum up waste
water (with reduced suction power).
NORMAL MODE
4
Clean the floor wet and vacuum up waste water.
HEAVY MODE
5
Clean the floor wet (with increased brush contact
pressure) and vacuum up waste water.
SCRUB MODE
6
Precleaning without vacuuming
Clean the floor wet and let the detergent act.
SUCTION MODE
7
Vacuum up the dirty waste.
POLISH MODE
8
Polish the floor at a high brush speed without apply-
ing liquid.
Suction bar holder
● When driving through narrow spaces, the suction
bar can be removed and hung in one of the open-
ings on the lid of the waste water tank.
●
The suction bar can be hung in the recess on the
waste water tank for storage.
English
Symbols on the device
Fresh water tank drain opening
Waste water tank drain opening
Fresh water tank filling level (50%)
Lashing point
* Mop holder
Filling system water connection
Waste water tank flushing system water
connection
Brush replacement
* optional
Installation
Unloading
1. Remove the packaging film.
2. Remove the strap.
Strap
1
Board
2
Block
3
Beam
4
3. Unscrew the block, squared timber and boards. The
components to be unscrewed are marked in grey in
the figure.
4. Place a ramp in front of the pallet with the un-
screwed boards and squared timber and fasten with
chipboard screws.
5. Install the batteries if the device was delivered with-
out batteries (see chapter "Before inital startup/ bat-
teries").
6. Drive the device forward and off the pallet (see
chapter "Operation / Driving").
Installing the brushes
1. The installation of the brushes is described in the
chapter "Maintenance work".