Yamaha E60HMHD Manual De Servicio página 354

SHIMMING (FOR USA AND CANADA)
Measuring steps:
(1)Install the bearing, shim(s) and reverse
gear onto the shimming gauge.
NOTE:
If the original shim(s) is unavailable, start
with a 0.50 mm shim.
Shimming gauge:
YB-34468-5............................
(2) Measure the specified measurement
(M) using the feeler gauge.
Feeler gauge:
YU-26900-8
YU-26900-9
NOTE:
Check the fit between the shimming gauge
and the reverse gear.
3. Adjust:
• Shimming-gauge-to-press-plate
clearance
Remove or add shim(s).
Available shim thickness:
0.10, 0.12, 0.15, 0.18, 0.30, 0.40,
0.50 mm
NOTE:
• (M0)-(M) should be as close to '0' as
possible.
• If the specified measurement (M) is larger
than the specified value (M0), add the
shim(s)
If the specified measurement (M) is smaller
than the specified value (M0), remove the
shim(s)
6-36
E
1