EN
4. Single (with one spout) and double (with
two spouts) portafilter handles come ready
assembled with single and double baskets
fitted.
5. The machine is now ready to begin dis-
MACHINE
pensing coffee. Remove the filter holder
and place the ground coffee inside the
filter basket. Press down on the coffee with
MAINTENANCE
the supplied tamper and install the filter
holder in the unit head. Press the button
corresponding to the desired product (1 - 5
fig_6.2) to begin the dispensing process.
6. After pressing the selected button, product
dispensing begins and ends automatically
when the programmed quantity is reached.
7. To heat the milk, immerse the tip of the
steam nozzle (1 - fig._6.3) under the sur-
face of the milk contained in a stainless
steel milk jug. Release heat into the milk
by turning the steam dispensing knob (2 -
fig._6.3) so the valve is fully open. Once the
milk has reached a temperature suitable for
consumption, turn the knob until the steam
supply stops. Remove jug from under the
steam nozzle.
fig_6.3
48
MACHINE
UNDER
UNDER
MAINTENANCE
BOXER
8. In order to prevent heated milk
from being sucked into the
i
i
boiler it is recommended that
you purge the steam wand
after heating milk. Purge by
releasing steam for a few
seconds into the atmosphere.
9. To dispense hot water, press the specific
symbol (6 fig._5.2) on the keypad and re-
lease the required amount of water into a
cup or container. Press the same key again
to interrupt hot water dispensing.
CAUTION:
THE WATER IS VERY HOT.
6.1 Manual control
Press the by-pass button (fig._6.4) to switch
the unit on the left to "manual" mode.
fig_6.4