Auchan 600138148 Manual Del Usuario página 23

1.2 DRILL SAFETY WARNINGS
1) Safety instructions for all operations
a) Wear ear protectors when drilling. Exposure to noise can cause hearing loss.
b) Hold the power tool by insulated gripping surfaces, when performing an operation where the
cutting accessory or fasteners may contact hidden wiring. Cutting accessory
contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
2) Safety instructions when using long drill bits
a) Never operate at higher speed than the maximum speed rating of the drill bit. At higher
speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece, resulting
in personal injury.
b) Always start drilling at low speed and with the bit tip in contact with the workpiece. At higher
speeds, the bit is likely to bend if allowed to rotate freely without contacting the workpiece, resulting
in personal injury.
c) Apply pressure only in direct line with the bit and do not apply excessive pressure. Bits can
bend causing breakage or loss of control, resulting in personal injury.
1.3 ADDITIONAL SAFETY WARNINGS
Protect the battery charger from rain and moisture. The penetration of water in a battery charger

increases the risk of electric shock.
Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of

battery may create a risk of fire when used with another battery.
Do not charge other batteries. The battery charger is suitable only for charging our lithium ion batteries

within the listed voltage range. Otherwise there is danger of fire and explosion.
Keep the battery charger clean. Contamination may cause the danger of electric shock.

Check the battery charger, cable and plug each time before using. Do not use the battery charger when

defects are detected. Do not open the battery charger yourself and have it repaired only by qualified
personnel using original spare parts. Damaged battery chargers, cables and plugs increase the risk of
electric shock.
Do not operate the battery charger on easily inflammable surfaces (e. g. paper, textiles, etc.) or in

combustible environments. There is danger of fire due to the heating of the battery charger during
charging.
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally

occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
Do not open the battery yourself. There is danger of a short circuit.

Protect the battery against heat, e.g., including against continuous sun irradiation and fire. There is a

danger of explosion.
Do not short-circuit the battery. There is a danger of explosion.

In case of damage and improper use of the battery, vapors may be emitted. In case of accidents,

provide for fresh air and consult a physician. The vapors can irritate the respiratory system. Ambient
temperature range for tool and battery use:-10℃ to 40℃
1.4. SPECIAL SAFETY INSTRUCTIONS FOR
BATTERY AND CHARGER
23
or fasteners