Auchan 600138148 Manual Del Usuario página 29

5. OPERATION
5.1 CHARGING THE BATTERY
The battery (5) must be charged before first use. Only after several charge and discharge cycles the battery
will attain full capacity.
Only use the provided adaptor (10) to charge the battery set.
Only charge the battery set when the ambient temperature is within 10° - 40 °C.
Plug the adaptor (10) to a 230 V alternating voltage source.
The battery (5) should under no circumstances be disassembled.
To remove the battery, press the battery release button (6) on the top side of the battery set and extract the
battery (5).
Connect the plug of the charger to the loading-socket (9) of the battery-set.
Red LED will light once the battery has been connected to the charger and the charging procedure will
proceed.
The battery set is completely loaded and ready for use once the green LED is lit and the red LED is OFF
after approximately 1 hour(fast charger) or 3-5 hours (slow charger).
5.2 POSITIONING AND REMOVING A DRILL OR SCREW BIT
This tool is equipped with a keyless chuck.
Open the chuck by turning the collar.

Insert the drill or screw bit in the chuck.

Close the chuck by firmly tightening the front collar (a) while holding the rear part (b) of the chuck with

the other hand.
In order to remove the drill or screw bit proceed in reverse order. Before positioning or removing a drill or

screw bit always remove the battery from the machine.
5.3 FORWARD/REVERSE SWITCH
Push the forward/reverse switch (2) from right to left side to drill holes and fasten screws.

Push the forward/reverse switch (2) from left to right side to loosen screws. Always wait until the motor

has come to a complete standstill before changing the direction of rotation.
5.4 ADJUSTING THE TORQUE
This machine has been fitted with an adjustable coupling (18+1 pos.) to limit the torque when tightening
screws.
Turn the adjustment collar (3) clockwise to reduce the torque and counterclockwise to increase the

torque. The correct setting depends on the type and size of the screw and the work piece.
In case of doubt, start with the lowest setting and increase the torque until you have reached the desired

result.
For drilling, turn the adjustment collar fully counterclockwise (to the drilling symbol).

5.5 SWITCHING ON AND OFF
Push the forward/reverse switch (2) on the left side or on the right side.

To switch on the machine, press the on/off switch (1).

To switch off the machine, release the on/off switch.

5.6 VARIABLE SPEED
Applying more pressure to the On/Off switch will increase the speed.

Applying less pressure to the On/Off switch will decrease the speed.

29