General Information; Set Up And Test The Lift; Hazard Information; Safety Regulations - Nussbaum POWER LIFT HL 2.50 NT Instrucciones De Servicio

• Operating the lift with defective safety devices or
improperly attached or non-functional safety and
protection devices.
• Non-compliance with information in the operat-
ing manual in terms of transport, storage, assem-
bly, commissioning, operation, maintenance and
fitting of the lift.
• Independent construction changes to the lift.
• Independent changes to the lift (e.g. drive ratios:
power, rotation speed, etc.)
• Improperly done repairs.
• Catastrophic cases due to foreign influences or
force majeure.
2

General information

Technical documentation contains important infor-
mation for safe operation and for retaining func-
tional safety of the lift.
• To verify lift set up, the set up protocol form is to
be signed and sent to the manufacturer.
• Forms are available in this inspection book for use
in verifying single, regular and extraordinary safe-
ty checks. Use the forms to document inspections
and leave the completed forms in the inspection
book.
• The lift master forms must record changes to the
construction and changes to set up location.
2.1

Set up and test the lift

Safety relevant work on the lift and safety inspec-
tions may only be done by personnel specifically
trained to carry it out. They are designated in gen-
eral and in this documentation as technical experts
and specialists.
• Technical experts are people (freelance expert
engineers, TÜV specialists) that may inspect and
assess due to their education and experience
with lift systems. They are knowledgeable in the
appropriate work safety and accident preven-
tion regulations.
• Specialists (competent people) are people who
have sufficient knowledge and experience with
lift systems and have participated in a special
factory training by the system manufacturer.
20110002 POWER LIFT HL 2.50 NT - HYMAX HL 5000 PH OPI
2.2

Hazard information

To become aware of the hazardous points and im-
portant information, the following three symbols are
used with the descriptive meaning. Pay particular
attention to text positions that are labeled by these
symbols.
i Note! Labels information about a key function
or points to an important remark!
Caution!
!
damage or other operating company property
damage if the highlighted process is not done
properly!
Danger!
and limb, if the highlighted process
is not done properly there is a mortal
danger!
3

Safety regulations

When working with lifts comply with legal accident
prevention regulations according to BGG 945:
inspection of lifts; BGR 500 operation of systems;
VBG 14.
Particular attention is drawn to compliance with the
following regulations:
• The max. load carrying capacity for lifts may not
be exceeded.
For this, see details on the model plate.
• When operating the lift , follow safety regulations
and operating instructions in the operating man-
ual.
• Only personnel aged 18 or over may operate the
lift independently, they must be trained in lift op-
eration and have their work verified by the com-
pany. They must be explicitly tasked with operat-
ing the lift (excerpt from BGR 500), see transfer
protocol.
Version 1.0
identifies a warning of possible lift
identifies a danger to life
49