Nussbaum POWER LIFT HL 2.50 NT Instrucciones De Servicio página 61

Visual
Spray
inspection
Time frame Maintenance
type position
12
1
11
2
10
365 x / 12
9 3
4
8
7 5
6
12
1
11
2
10
365 x / 12
9 3
4
8
5
7
6
12
11 1
2
10
365 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
365 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
365 x / 12
9 3
4
8
7 5
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
20110002 POWER LIFT HL 2.50 NT - HYMAX HL 5000 PH OPI
Oil
The lift cylinder can sweat and small oil droplets can form on the base
plate, this is however, not a leak.
Model and information signs, labels, brief operating instructions,
safety stickers and warning information are to be cleaned and ex-
changed if damaged.
A
Optional: Check the foot bumper for condition and function. Ex-
change if damaged.
B
The rubber acceptance plate is to be checked for wear and replaced
if necessary.
Optional: Check the CE stop and warning signal for condition and
function. Exchange if damaged.
The CE stop must switch a min. of 120 mm from the hazard.
During assembly and maintenance always check the condition of
electrical lines. All cables and lines must be secured so they cannot be
crushed, kinked or contact any moving assembly.
C
Check the tracks and the lift rail equalization parts for wear. After
cleaning, grease with a multi-purpose grease.
Version 1.0
Clean with
Lubricate compressed
air
Maintenance plan
Clean Inspect
61