Regular Safety Inspection And Maintenance - Nussbaum POWER LIFT HL 2.50 NT Instrucciones De Servicio

14.1 Regular safety inspection and maintenance

i Copy, complete and leave in the inspection book
Test step:
OK = "o"
Model plate
Brief operating instructions on the column
Operating manual
Load capacity details on the system
Condition / function operating lever and button
Condition / function of CE stop and warning signal
Label "LIFT, LOWER"
Condition, lockable main switch
General system condition
Condition of covers
Check the play of sliding parts on the lift columns
Condition/ function lifting arm
Condition/ function lifting arm block
Condition/ function lifting arm movement
Condition/ function carrier plate / support parts
Condition / function of foot bumper (optional)
Securing the lifting arm bolts
Load bearing construction (deformations, cracks)
*) Enter one of the following: "o"= OK, „-"= Defect or missing and / or "N" = Retest!
Remarks: ____________________________________________________________________________________________
______________________________________________________________________________________________________
______________________________________________________________________________________________________
Safety inspection done on:
Performed by company:
Name, address of specialist: ______________________________________________________________
Result of inspection:
______________________________
Signature of specialist
If requested to take care of deficiencies
Deficiency removed on:_________________________________ ______________________________
(use a new form for reinspection!)
20110002 POWER LIFT HL 2.50 NT - HYMAX HL 5000 PH OPI
Defective or missing = "-"
_____________________________________________________________
______________________________________________________________
Continued operation questionable, reinspection required
Continued operation possible, remove defects by _______________
No deficiencies, continue to operate
Version 1.0
Serial number: ___________________________________
Post-inspection = "N"
Condition, function riser extension
Condition of cross-beam
Condition of concrete floor (cracks
Fastening anchor torque
Fastening screw torque
Condition, hydraulic unit
Paint condition
Cylinder condition
Condition wiper cylinder
Hydraulic system leak-tightness
Hydraulic oil filling level
Condition of hydraulic lines incl. screw
fittings
Functional test "overflows"
Condition electrical lines
Condition / function energy set (optional)
Condition of weld seams
Functional test, system with load
______________________________
Operating company signature
Operating company signature
87