Asap Ii Seating Adjustment; Q.SEat Pan And Back Size Adjustments; R.REpairing Or Replacing A Tire - Sunrise Medical Quickie QM-710 Manual De Instrucciones

Q M- 7 10/7 15HD/ 72 0
P. ASAP II SEATING ADJUSTMENT
Please refer to the ASAP Seating Adjustment Guide for details on how to adjust the seat
depth, seat width, armrest height and backrest angle.
Pre-tilt and Seat-to-floor height
62
Pre-tilt positioning:
• For 0º pre-tilt use hole positioning number (X) on the packer module.
• For 3º pre-tilt use hole positioning number (Y) on the packer module
• For 6º pre-tilt use hole positioning number (Z) on the packer module
Seat-to-Floor Height: 63
Seat-to-floor height is accomplished by using the same hole number on both the front and
rear posts when raising or lowering the seated position.
DO NOT Increase the front post height independent from the rear posts when providing
seating pre-tilt. Use only the Pre-tilt positioning holes on the Packer module (Figure 20).
NOTE– For chairs configured with seat elevator and SPOT Tilt, do not increase the pre-tilt to
greater than 0º.
For chairs configured with SPOT tilt and seat elevator do not increase the seat-to-floor
height greater than 3" from lowest position.
Q. SEAT PAN AND BACK SIZE ADJUSTMENTS
Your ASAP II seating system can be adjusted to a wide range of widths and depths to
accommodate specific user needs. Seating dimensions should only be altered by a trained
professional and may require new seat cushions. Please refer to the QM-710/715HD/720
Service Manual for more detailed instructions on how to customize the size of your seat.
R. REPAIRING OR REPLACING A TIRE
WARNING
Residual air pressure in tires can cause severe injury. Make sure you release all air in tire
before attempting to service or repair tires.
1. Drive Wheels:
a. Elevate and securely support chair so that wheel is off the ground. Release all air from
tire.
b. Remove the three main lugnuts (A).
c. Remove the Drive wheel/tire assembly
2. Air Tube:
a. To replace the air tube, remove the six hex screws (B) so that the rims can be
seperated.
b. Seperate the two halves of the rim and remove tire and solid insert
f. Repair or replace.
g. Reassemble the wheel. Use a torque setting of 420 in-lbs to re-tighten the bolts.
h. Install the wheel on the chair using a torque setting of 180 in-lbs to retighten the
bolts.
i. Inflate the tire to the proper pressure level (listed on the tire sidewall)
MK-100158 Rev. F
64
62
63
64
WARNING
65
XI. DEALER SERVICE AND ADJUSTMENT
30
XHole 0°
YHole 3°
ZHole 6°
Front
Post
1st Hole
2nd
3rd
4th
5th
6th
Rear Post
1st Hole
2nd Hole
3rd Hole
4th Hole
5th Hole
6th Hole
62
63
64
65