CAUTION
Using the product in safety mode
Falling due to unexpected product behaviour because of changed damping behaviour.
►
The warnings/error signals (see Page 63) have to be observed.
5 Scope of Delivery and Accessories
Scope of Delivery
•
1 pc. 757L16* power supply
•
1 pc. 4E50 Battery Charger for C-Leg
•
1 pc. leg orthosis (aligned) with 17B300=* C-Brace joint unit
•
1 pc. 646D458 instructions for use (user)
•
1 pc. 647F449 orthotic passport
•
1 pc. cosmetic case for XEKT2337 battery charger
6 Charging the battery
The following points must be observed when charging the battery:
•
The capacity of a fully charged battery is sufficient for one full day.
•
We recommend charging the product every day when used on a daily basis.
•
When used daily, the complete charging unit (power supply – battery charger) may remain
plugged into the wall socket.
•
The battery should be charged for at least 3 hours prior to initial use.
6.1 Connecting the power supply and battery charger
1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see
fig. 1).
2) Connect the round, three-pin plug of the power supply to the 12V receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger
light up (see fig. 3).
→ If the green LED on the power supply and the green LED on the battery charger do not light
up, there is an error (see Page 63).
46
2
3