Ottobock C-Brace Instrucciones De Uso página 64

Beep signal
Ongoing short beep
signal
Continuous beep sig­
nal
Error while charging the product
LED on LED on bat­
power tery charger
supply
64
Event
Active safety mode
Walking possible with restrictions
Severe error:
e.g. failure of valve drives
Possibly no switching into safety
mode
Undetermined product behaviour
Total failure:
Electronic control no longer pos­
sible
Safety mode active or undeter­
mined valve state
Undetermined product behaviour
Error
Country-specific plug adapter not
fully engaged on power supply
Non-functional wall socket
Defective power supply
No connection between battery
charger and power supply
Defective battery charger
Battery is fully charged (or con­
nection with product is interrup­
ted).
Required action
Restore contact with the spring or
sensor screw. By pressing the top
button on the joint unit (5 seconds),
check the sensor contact. The
check is confirmed by a long beep
signal.
If this error persists, the product
must be inspected by an author­
ised Ottobock Service Centre.
The product must be inspected by
an authorised Ottobock Service
Centre
The product must be inspected by
an authorised Ottobock Service
Centre
The product must be inspected by
an authorised Ottobock Service
Centre
Resolution
Check whether the country-spe­
cific plug adapter is fully
engaged on the power supply.
Check wall socket with another
electric appliance.
The battery charger and power
supply must be inspected by an
authorised Ottobock Service
Centre.
Check whether the charging
cable plug is fully engaged on the
battery charger.
The battery charger and power
supply must be inspected by an
authorised Ottobock Service
Centre.
Take note of the different beep
signals to identify the given char­
ging state.
Upon connecting or disconnect­
ing the battery charger, a self-test