Orved Evox 31 Hi-Line Manual De Uso página 36

INSTALLATION
CAUTION!
Never start the machine if there is no oil in the pump!
5) Connect the machine to the electrical mains.
• Before installing the appliance, make sure any pre-existing electrical systems comply with the law and correspond
to the specifications shown on the ID plate of the appliance being installed (V, kW, Hz, and available power).
• The appliances are supplied with a power cable 200 cm long with standard Schuko 16A plug; the outlet must have
a 10A fuse and must be easily accessible.
ELECTRICAL HAZARD
• Check that the power cable is not damaged or restrained.
• Insert and disconnect the plug, pulling on the plug and never on the cable.
CAUTION!
• Make sure the plug is accessible even after the unit has been installed!
• If the appliance plug is not easily accessible, the power mains must be equipped with devices for om-
nipolar disconnection, with a gap between the contacts allowing complete disconnection in category
III overvoltage conditions.
• If the entire length of the cable is not used, DO NOT roll it up but leave it free and make sure it does not obstruct
or endanger passers-by.
• Make sure the power cable does not come into contact with liquids of any type, sharp or hot objects and cor-
rosive substances.
• Do not allow children or animals to play with the power cable.
6) Clean the vacuum chamber and lid before use.
7) Check the absorption using an ammeter.
8) Run at least one complete vacuum packaging cycle for bags.
9) Inform the client of the exact use of the appliance, with specific reference to the use and requirements of the
client themselves.
36
Rev. 02 - 06/2018 - Cod. 1500339 - Vacuum packaging machine user manual
31
evox
Hi-Line