To Mount And Remove Rear Wheels; Wheel Locks; Hub Locks; Sideguard Mount - Sunrise Medical Zippie ZONE Manual De Instrucciones

E N G L I S H
F. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both quick-release axles are
locked. An unlocked axle may come off during use and cause a fall.
NOTE– Setting the wheelchair on a flat surface, such as a workbench or table, helps make these proce-
dures easier.
1. To Install Wheel
a. Depress quick-release button (A) fully.
b. Insert axle (B) through hub of rear wheel.
c. Keep button (A) depressed as you slide axle (B) into camber plug (C).
d. Release button to lock axle in camber plug. Adjust axle if it does not lock.
See Section B.
e. Repeat steps on other side.
2. To Remove Wheel
a. Depress quick-release button (A) fully.
b. Remove wheel by sliding axle (B) completely out of camber plug (C).
c. Repeat steps on other side.
NOTE– The axle is not locked until the quick-release button pops out fully (A). Check that the axle is
locked by pulling on the wheel in the direction of the axle.
G. WHEEL LOCKS
Wheel locks are installed at Sunrise and should be adjusted by your qualified service person.
Inspect wheel locks weekly per the maintenance chart. Do not use your chair UNLESS you are sure both
wheel-locks can fully engage. A wheel-lock that is not correctly adjusted may allow your chair to roll, or
turn unexpectedly.
Wheel-locks must be adjusted after making sure the tires have the correct air pressure. When fully engaged,
the arm should be imbedded into the tire at least 1/8" to be effective.
If you find the wheel locks have slipped or are not working correctly contact your service provider for prop-
er adjustment.
4
H. HUB LOCK
To operate Hub Lock
1. To lock rear wheels, press button A. Lever B will flip outward.
2. To unlock wheels, press lever B back down until button A pops back out. Each lever
operates one side of the chair. To fully lock chair, both buttons must be pushed.
NOTE– Do not engage hub lock when chair is in motion.
5
To adjust the cables
1. Loosen jam nut (C) using a 10mm wrench.
2. Turn adjustment screw (D) in or out as necessary. Turning screw toward the housing
will loosen the cable. Turning screw away from the housing will tighten the cable.
3. Re-tighten jam nut (C) against lever mount.
4. Repeat steps 1-3 for opposite side of chair as necessary.
I. SIDEGUARD MOUNT
To Operate
1. To lock, lift handle (E) and pull lever towards backrest until it engages.
2. To unlock, lift handle (E) and slide forward to front of sideguard until it drops into
position.
To adjust the cables
1. Loosen jam nut (C) using a 10mm wrench.
2. Turn adjustment screw (D) in our out as necessary. Turning screw upward will loosen
cable, turning downward will tighten cable.
3. Re-tighten jam nut (C) against lever mount.
4. Repeat steps 1-3 for opposite side of chair as necessary.
WARNING
3
WARNING
5
4
6
VIII. USE AND MAINTENANCE
1 2
15
1
A
2
B
C
3
B 4
A
Locked
Unlocked
5
C
D
6
E
116100 Rev. D