Anti-Tip; Single Post Height-Adjustable Armrests; Padded Swing-Away Armrest - Sunrise Medical Zippie ZONE Manual De Instrucciones

E N G L I S H
J. ANTI-TIPS
7
Sunrise Medical recommends anti-tip tubes for all wheelchairs. Use torque setting of 62
in-lbs. (7 Nm) when installing anti-tip tubes.
1. Inserting Anti-tip Tubes Into Receiver
a. Press the rear anti-tip release button (F) on the anti-tip tube so that both release pins are
drawn inside.
b. Insert the anti-tip tube (G) into the anti-tip receiver (H).
c. Turn the anti-tip tube down until release pin is through the receiver mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Tube Wheel
The anti-tip wheels may have to be raised or lowered to achieve proper clearance of
1 1/2" to 2".
Press the anti-tip wheel release button (I) so that both release pins are drawn inside. Raise or
lower to one of the three predrilled holes (J). Release button. Adjust the second anti-tip tube
wheel the same way. Both wheels should be the same height.
3. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing
curbs. Press the rear anti-tip tube release button - F. Hold button in and turn anti-tip tube
up. Release the lever and repeat with second anti-tip tube. Remember to return anti-tip
tubes to down position after completing maneuver.
K. SINGLE POST HEIGHT-ADJUSTABLE ARMRESTS
1. Installation
a. Slide the outer armpost into the receiver mounted to the wheelchair frame.
b. The armrest will automatically lock into place.
2. Height Adjustment
a. Rotate height release lever (2) to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against armpost.
d. Push arm pad (4) until upper armpost locks firmly into place.
3. Removing Armrest
a. Pull lever 3 and lift entire arm.
4. Replacing Armrest
a. Slide armrest back into receiver.
b. Make sure that the unlocking lever (3) returns to the locked position
against armpost.
L. PADDED SWING-AWAY ARMRESTS
Swing-away armrests can be detached or can swing away to allow lateral transfers.
They are height adjustable (6" in 1" increments) by moving bolts (A) up or down in
predrilled holes on armrest bracket.
Swing-away, removable armrests are installed by sliding armrest into receiver (B) on back
frame.
Swing-away, angle adjustable
To change the angle, remove bolts (C), reposition to needed angle. Reinsert bolt and tighten.
Padded swing-away armrests are not transfer devices and must be rotated out
of the way prior to transferring. Failure to do this on a regular basis can result
in decreased chair integrity and may void the warranty.
116100 Rev. D
8
(Optional)
WARNING
VIII. USE AND MAINTENANCE
9
(Optional)
11
10
16
7
H
G
F
I
J
8
9
4
6
5
2
1
3
7
1. Outer armpost
2. Height Release
Lever
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Receiver
10
A
B
11
C