Footrest Height Adjustment; Depth Adjustable Backrest - Sunrise Medical Zippie ZONE Manual De Instrucciones

E N G L I S H
M. FOOTREST HEIGHT ADJ USTMENT
To adjust the height of your footrest, loosen the screw (B) on both footrest clamps. Slide
the footrest up or down to the new desired height and tighten the two set screws. Use a
MAX torque setting of 62 in-lbs (7 Nm). (Frame damage may occur if overtightened.) It is
recom-mended that you maintain a minimum of 2.0 inches (5 cm) between the lowest point
on the footrest and the floor. This will provide adequate clearance for uneven surfaces and
prevent damage to your footrest.
Flip-up Footrest
To adjust the angle of the Flip-up Footrest, loosen two bolts (C) and rotate the footrest
angle stop bracket. Once positioned, retighten bolts (C) to 92 in-lbs. For certain narrow
widths, only one bolt will be present.
High Mount Footrest Mount
1. Loosen all four socket heads (D) on both sides of the chair.
2. Slide footrest to desired height.
3. Tighten socket to 62 in-lbs on both sides.
N. DEPTH ADJUSTABLE BACKREST
The backrest may be adjusted for depth change by loosening the two bolts on each side of
the axle backrest bracket (4 bolts total) (A) and sliding the assembly. Once each side (RH &
LH) are positioned and aligned with each other, tighten bolts (A) to specified torque.
O. TENSION ADJUSTABLE SEAT SLING ADJUSTMENT
The tension adjustable seat sling (C) can be adjusted for depth change by loosening the
front Velcro strap (B) and unfolding to the desired depth. Once the sling length is set,
replace and re-tension the front tension adjustable sling (B).
To increase depth, unfold Velcro flap (B) to add one or two additional inches.
Straps on frame (D & E) should be tightened before replacing sling (C).
12 13 14
15
17
VIII. USE AND MAINTENANCE
D
16
C
B
D
E
12
B
13
C
14
15
A
16
116100 Rev. D