PROPAIN spindrift 2021 Instrucciones De Montaje página 30

// MOUNTING THE REAR WHEEL
1 2
Activate the Cage Lock function. Pull the cage of the rear 1. Remove the thru axle from the frame.
derailleur forward and press the Cage Lock button with the
2. Remove the transport securing device that is fitted
symbol .
between the brake pads.
→ The rear derailleur cage remains tilted forward when
3. Store the transport securing device for future transport
the Cage Lock function is activated. This simplifies the
of your bike.
installation of the rear wheel.
4 5
Screw the thru axle into the dropout using a 6 mm hex key Deactivate the Cage Lock function. Pull the cage of the
and tighten the thru axle to a torque of 12 Nm. derailleur slightly forward and carefully return the derailleur
to its original position.
3
1. Insert the rear wheel into the dropout of the frame.
→ The brake rotor must be placed between the brake
pads.
→ Put the chain on the smallest sprocket of the
cassette.
1
2
2. Slide the thru axle from the brake side (left in the
direction of travel) into the frame dropout and hub of
the wheel.
// MOUNTING THE PEDALS // MOUNTING THE SADDLE
1 1
R L
One of the pedals has a right- and the other a left-hand thread.
Most pedals have the letter "L" and "R" stamped on the end of
the thread. Some pedals come with a groove in the flange of
the left pedal.
Unscrew the bolts of the saddle clamp and remove the upper
1. Slightly grease pedal thread.
clamp.
2. If washers were provided with the cranks of your bike, fit
2
them on the pedal threads.
3. Turn the left pedal counter-clockwise to screw it into the
thread of the left crank arm and tighten the pedal to a
torque of 35 Nm.
4. Turn the right pedal clockwise to screw it into the thread
of the right crank arm and tighten the pedal to a torque
of 35 Nm.
1. Attach the upper clamp to the saddle frame.
2. Adjust the saddle to your personal preferences and
screw in the clamping bolts.
3
Adjust the seat height:
Caution: When adjusting the seat height, the cable of the seat
post must be pushed or pulled in or out the frame. Otherwise
the cable may get damaged!
1. Open the saddle clamp.
2. Push the seat post carefully and slowly into the frame
or pull the seat post out of the frame. At the same time
push or pull the cable in or out the frame.
3. Close the saddle clamp.