PROPAIN spindrift 2021 Instrucciones De Montaje página 32

// REMOVING THE SHOCK
1 2
// MOUNTING THE DERAILLEUR HANGER
1. Loosen and remove the upper shock bolt first. Pulling 1
out the bolt is made easier by slightly lifting the
rear end.
2. Now also remove the lower shock bolt.
3. Pull the lower end of the shock forward as shown in
picture 2.
4. Rotate the shock 90 degrees clockwise around the
shaft.
5. Pull the shock out from the drive side.
1.
2.
2
Position 0
L
Insert the UDH derailleur hanger from the inside into the 1. Fix the derailleur hanger with the bolt. Make sure that
dropout of the frame. the washer is installed between the bolt head and the
frame. Otherwise the frame can be irreparably damaged.
Turn the derailleur hanger forwards to position 0 and as
far as it will go on the frame. 2. Tighten the screw with a torque of 25 Nm. Make sure
that the screw has a left-hand thread and whether your
torque wrench is suitable.