Gsm/Gprs" Tab - ORi X-zone Com Manual De Instrucciones

Operating Manual X-zone Com - Configuring X-zone Com
Fig. 5.14: The "Data logger" tap allows you to set the logging interval, view the status and clear the data memory.
Interval: "Interval" permits users to determine the transmission and storage frequency of the
measurement results. You may select either seconds (10-59 sec.) or minutes (1-60 min.).
:
Status "Total" displays the number of saved data sets and "unread" shows the number of data sets
not yet sent. In addition, you'll see the available memory capacity.
Daten logger: [Delete] empties the device's data memory. You will be asked if you are sure you want
to delete the contents before the system proceeds.
GSM/GPRS
5.4.3 "
To use the GSM/GPRS network to communicate data, you have to make several settings. These set-
tings will vary depending on your mobile phone provider. You may have to ask your provider to supply
this information.
Fig. 5.15: Mobile phone settings. You can obtain the settings you need to use for the SIM card you installed from
your mobile phone provider. Click [Modem status] to display the connection parameters and carry out a function
test.
NOTE
The data logger is designed as a circular buffer, i.e. it over-
writes the oldest data when the memory is full.
" tab
NOTE
You have to transmit every setting you make once to X-zone
Com, by clicking [Upload].
35