Getting Started; Toolbox Installation; Inserting And Removing Test Modules; Turning The Unit On - EXFO FTB-8510B Guia Del Usuario

Tabla de contenido

Idiomas disponibles

Getting Started

If the FTB-8100 Series Transport Blazer has been purchased at the same

time as the FTB-500, the FTB-8100 Series module is pre-installed with the

appropriate ToolBox software version.

ToolBox is the baseline software and thus needs to be installed on the

FTB-500 before using the FTB-8100 Series module.

Note: Refer to the FTB-500 platform user guide for more information on ToolBox

installation procedure.

Never insert or remove a module while the FTB-500 is turned on.

This will result in immediate and irreparable damage to both the

module and unit.

When the laser safety light (

one of your modules is emitting an optical signal. Please check all

modules, as it might not be the one you are currently using.

Note: Refer to the FTB-500 platform user guide for more information on how to

insert a module into the FTB-500 or to remove a module from the FTB-500.

For FTB-8140, use respectively the retaining screw number 2, 3, or 4 (from

bottom to top) depending if the module is inserted in slots 0 to 5, 1 to 6, or 2

Turn on the FTB-500. Refer to the FTB-500 platform user guide for more

information.

SONET/SDH Application

) is flashing on the FTB-500, at least

Tabla de contenido