EXFO FTB-8510B Guia Del Usuario página 717

2. Interface connector selection:
2a. From the data path
2b. For Decoupled test
2c. Press Next.
SONET/SDH Application
selector, press the
desired electrical interface connector.
BNC for DS3, E4, E3, E2, and E1.
Bantam for DS1and E1.
RJ-48c for DS1 and E1.
mode, both TX and
RX ports have to be
selected and
configured:
First select the
interface type for
TX from the data
path selector then
proceed with the
rest of the test setup steps to set the test parameters for the TX
interface. At the end, do not press Finish yet. Press Back to return
to the RX/TX selection screen and select the interface type for RX
from the data path selector then proceed with the rest of the test
setup steps to set the test parameters for the RX interface.
Creating and Starting a Test Case
Typical Test Cases
67