DSn Tabs
FDL TX
FDL TX
Press TEST, DSn-PDH, and FDL (under DSn-PDH TX).
Note: FDL TX is only available for DS1 interface with ESF framing. For Dual RX
test, FDL is only available for the primary DS1 TX/RX port.
The FDL TX tab is used to set and configure the Bit-Oriented Messages
(BOM) of the Extended Super-Frame (ESF).
Configuration
Enable FDL: Allows the activation of the Facility Data Link testing. This
setting is disabled (Off) by default unless otherwise set during the test
setup.
280
FTB-8100 Series Transport Blazer