Fdl Prm Content Rx - EXFO FTB-8510B Guia Del Usuario

FDL PRM Content RX

Press TEST, DSn-PDH, and PRM Content (under DSn-PDH RX).
Note: FDL PRM Content RX is only available for DS1 interface with ESF framing
when Enable FDL from FDL TX/RX is enabled. For Dual RX test, FDL is only
available for the primary DS1 TX/RX port.
Current Performance Report Message
Each PRM is listed into four lines called Time (t0, t0-1, t0-2 and t0-3).
Where:
Time
t0 represents the valid PRM message received in the last second of
measurement (bytes 5 and 6).
t0-1 represents the message one PRM ago (bytes 7 and 8).
t0-2 represents the message two PRM ago (bytes 9 and 10).
t0-3 represents the message three PRM ago (bytes 11 and 12).
SONET/SDH Application
DSn Tabs

FDL PRM Content RX

291