Assembling The Bearing And Guard - Stihl Cutquik TS 700 Manual De Instrucciones

!
Warning!
Do not operate your cut-off machine if
the muffler is damaged, missing or
modified. An improperly maintained
muffler will increase the risk of fire and
hearing loss. Never touch a hot muffler
or spill fuel or other flammable liquid
over it. Burn injuries or fire will result. If
your muffler was equipped with a spark-
arresting screen to reduce the risk of fire
(e. g. in the USA, Canada and Australia),
never operate your cut-off machine if the
screen is missing or damaged.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the Owner's
Manual.
Store wheels on a flat surface in a dry
place, preferably at a constant
temperature, where there is not a risk of
frost. Do not store a cut-off machine with
a wheel mounted on the machine. Store
cut-off machine in a high or locked
place, away from children.
Empty the fuel tank before storing for
longer than a few days. Store fuel only in
correctly labeled and approved
containers. Avoid direct skin contact and
do not inhale the gas vapors.
TS 700
Assembling the bearing and
guard
The bearing with guard is mounted on
the inboard side of the cast arm by the
manufacturer.
The bearing with guard can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance; outboard
mounting is recommended when the
machine is mounted on a STIHL cut-off
machine cart.
Outboard mounting
: Disassemble the abrasive wheel
(see "Fitting / replacing an abrasive
wheel")
English / USA
: Move the guard to the position
illustrated and pull out the plugs
(arrows).
:
Fit the adjusting lever (1) in
position A.
:
Press the plugs into the free holes.
: Unscrew the nuts (2).
:
Remove the banjo bolts (3).
19