Stihl Cutquik TS 700 Manual De Instrucciones página 21

English / USA
: Turn the guard in the direction of the
arrow until the adjusting lever points
downwards.
20
To relax the V-belt,
:
loosen the hexagon bolts (4) and
turn the tensioning nut (5)
anticlockwise with a combination
wrench – approx 1/4 turn, up to the
stop = "0".
: Remove the hexagon bolts.
: Pull the V-belt guard (6) off to the
front and remove the V-belt from the
front pulley.
:
Remove the bearing with guard (7).
7
: Fit the bearing with guard (7) on the
outboard side of the cast arm,
guiding the V-belt over the belt
pulley at the same time.
: Refit the V-belt guard.
:
Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
:
Screw in the hexagon bolts, but do
not tighten them yet.
:
Refit the water attachment parts to
the guard.
Continue as described in the chapter
"Tensioning the V-belt".
TS 700