Replacing The V-Belt - Stihl Cutquik TS 700 Manual De Instrucciones

: It must be possible to turn the rope
rotor on another half-turn when the
rope has been drawn out
completely.
If not, the spring has been tensioned
too tightly and may break. Remove
one turn of the rope from the rotor.
:
Refit the starter cover.
:
Press the remaining rope into the
handle.
Replacing a broken rewind spring
:
Remove the rope rotor as described
for "Replacing the starter rope".
7
7
:
Remove the screws (7).
: Remove the spring housing and
spring parts.
TS 700
: Fit a new spring housing with the
bottom upwards.
: Turn in the screws.
:
Refit the rope rotor.
:
Tension the rewind spring
:
Refit the starter cover and screw it
into place.
:
Press the cable clip together and
refit it in the starter cover.
If the spring has popped out of the
spring housing:
:
Refit it, working anticlockwise from
the outside inwards.
English / USA

Replacing the V-belt

: The arrow on the tensioning nut (1)
must point to "0". Turn the
tensioning nut anticlockwise
with the combination wrench –
approx. 1/4 turn, until it reaches "0".
:
Remove the hexagon bolts (2).
:
Pull the V-belt guard (3) off to the
front and remove the V-belt from the
front pulley.
:
Remove the bearing and guard.
:
Press the cable clip (4) together and
pull it out of the starter cover (5).
: Remove the screws (6) from the
starter cover.
:
Remove the starter cover.
:
Remove the defective V-belt from
the cast arm.
35