Stihl Cut-Off Machine Cart; Storing The Machine - Stihl Cutquik TS 700 Manual De Instrucciones

English / USA
: Carefully fit a new V-belt (7) in the
cast arm and in the V-belt pulley (8)
on the power unit.
:
Fit the starter cover.
:
Hold the bearing with guard against
the cast arm.
:
Insert the V-belt in the V-belt
pulley (9).
:
Refit the V-belt guard.
:
Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
:
Screw in the hexagon bolts, but do
not tighten them yet.
:
Press the cable clip together and
refit it in the starter cover.
Continue as described in the chapter
"Tensioning the V-belt".
36

STIHL cut-off machine cart*

The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20 in
a matter of minutes.
The cut-off machine cart makes it easier
to
– repair damaged carriageways
– apply carriageway markings
– cut expansion joints
* see "Guide to using this manual"

Storing the machine

For periods of three months or more.
:
Drain and clean the fuel tank in a
well ventilated place.
:
Run the engine until the carburetor
is dry. This helps to prevent the
carburetor diaphragms sticking
together.
: Remove the abrasive wheel.
: Thoroughly clean the machine,
paying special attention to the
cylinder fins and air filter.
:
Store machine in a safe and dry
place, out of reach of children and
other unauthorized persons.
TS 700