Cleaning The Cutter - Marsh 5HT Manual Del Propietário

Maintenance

Cleaning the Cutter

Figure H
Figura H
25006/00042 Rev I
7. Clean the brush by soaking it in warm soapy water for five minutes. Rinse it with
clear water. Clean the tank by rinsing it with warm, clear water.
8. Refill the water bottle with fresh water.
1. Remove the water bottle and water regulator.
2. Remove the brush tank by pressing the holding clip to the left.
Caution! The water in the brush tank may be hot if your model has a heater.
3. Pour the water out of the moistening system.
4. Remove the cutter by removing the two mounting screws above the blade (see
Figure H).
5. Clean both sides of the cutter with warm water.
6. Lubricate the cutter by putting a small amount of grease at the joint between the
blades (see Figure H).
7. Reattach the cutting blade to the taper by replacing the two mounting screws.
Apply Grease Here
Point de graissage
Screw
Vis
Tornillo
Lubricar aquí
Cutter
Couteau
Cortador
Brush Tank Assembly
Ensemble bac à brosse
Conjunto del tanque de la escobilla
25