Pump Assembly And System Check; Figure 5. Connect Pump Accessories - Johnson & Johnson DePuy Synthes FMS VUE II Manual Del Usuario

4.4

Pump Assembly and System Check

To assemble the FMS VUE II pump:
1 . Connect the power cord to the power source .
2 . Connect the other end of the power cord to the rear panel of the pump .
3 . Connect the accessories to the pump (Figure 5) .
4 . Turn the pump ON by pressing "|" on the power switch on the front of the pump
(Figure 5) . The software versions appear on the display followed by the elevation settings .
See Section 6 .1 .1 to adjust the joint-to-pump elevation settings .
1 2
1 Handpiece (optional)
2 Remote Hand Control (optional)
3 Foot Pedal (optional)
4 Power Switch
Figure 5. Connect Pump Accessories
24
4
3