SICE S 58 LL Manual De Instrucciones página 71

turn on together for approx. two seconds as a self-test.
The RX unit starts the hydraulic pump motor each time it receives a command from
the control lever's TX unit and the pump will remain in operation for an additional 5
seconds after the last command is received.
WARNING
When locking a rim, continue to operate the control to make sure that the maximum
pressure (180 bar) has been reached, which can be checked on the pressure gauge
(C, Fig. 11).
WARNING
The distributor-turntable pressure tests are performed with the wheel mounted.
WARNING
When working, always control the pressure of the turntable
NOTE.
Also check the pressure during tyre mounting and demounting operations; to solve
rim settling problems, continue to operate the locking control.
WARNING
The ground control lever (trolley type) must never be positioned in an area where
water can stagnate.
WARNING
For the version with the ground control lever with the application of the optional
radio kit, the commands are sent to the machine via the radio transmitter. To
guarantee maximum battery life, the transmitter is only activated for the dura-
tion of the control impulse (the green LED on the radio-control box lights up). If
the transmitter batteries are run down (the yellow LED on the radio update kit
box lights up) the control unit can be connected to the machine using the original
cable. If the yellow LED lights up, it is advisable to recharge the batteries with the
battery charger connected to the 230V mains, single-phase, 50/60 Hz.
- E
- Operator's manual
nGlISH
71