SICE S 58 LL Manual De Instrucciones página 77

Position the tool so it is in contact with
the tyre, making sure that a safe distance
is kept from the rim in order not to bump
it during the subsequent search phase;
simply make any small corrections manu-
ally.
· Advance the tool while simultaneously
rotating the turntable. (fig. 26).
· When near the well, operate the Search
control.
- Once the bead is hooked, return the tool
to the horizontal position with the Search
control (Fig. 27).
· Translate the tool outward to align the
outer edge of the rim with the vertical
notch on the tool pad. (fig. 28).
· Use the manipulator control lever to
start the automatic demounting process,
moving the tool to its end of travel to
lift the bead to the exterior of the rim
(Fig.29).
· Operate the control for rotating the
turntable to bring the bead out of the rim
(Fig.30).
· When demounting is complete, move the
tool to the right and away from the rim,
and activate the demounting lever for the
opposite direction. The rim returns to its
original position and the tool will return to
the horizontal position.
· With tyres with an inner tube, place the
wheel on the floor and pull the rim back to
create the space necessary for removal.
(fig. 31).
REAR BEAD DEMOUNTING:
· Use the S.T.S. control to move the tool
unit to the other side of the wheel.
- E
- Operator's manual
nGlISH
28
29
30
31
77