John Bean B 800 Manual Del Operador página 76

76
4-11
4-12
5-32
Operation "MANUAL MODE"
5.14 Wheel Profi les function
To balance more than one wheel of the same type and
with the same nominal dimensions, simply set the data
for the fi rst wheel only. The data set remain until other
new data are set or the machine is switched off.
Note: This function in used in manual mode only.
WHEEL PROFILES (Figure 4-11).
To make the wheel parameters available permanently
use the WHEEL PROFILES function.
The wheel profi les allow you to memorise the values
of certain wheel types that are often balanced in
the workshop. Naturally this bypasses the task
of repeatedly setting wheel data. This function is
particularly useful for workshops that carry out series
fi tting of tyre/rim assemblies or frequently handle the
same wheel types (e.g. workshops that offer rims for
retrofi tting).
The once-only storage of the rim data in the profi les
guarantees that the same correction planes are always
used, in particular for alloy wheels, thus providing
consistent balance quality.
The function can be used to save the following data:
– Nominal wheel dimensions
– Values measured
– Position of weights (Alu mode)
– Type of Vehicle
– Traceability positions (list from 1 to 9)
– Number of spokes (if loaded previously)
How to access
:
The WHEEL PROFILES menu can be accessed at
any time.
From WHEEL DATA ENTRY Menu (Fig. 4-12),
— Press the "SPECIAL" key (Fig. 5-32).
The WHEEL PROFILES screen is displayed (Fig. 4-11)