Fault - Angelo Po 091FR1I Manual De Uso E Instalación

8 - Check that the "slow
start-up" device is cor-
rectly positioned.
9 - Switch off the appliance,
turn off the gas supply tap ,
and disconnect the pres-
sure gauge (C) and retight-
en the screw (B).
10-Close the door (A) when
the operation is complete.
The appliance has been tested before being put
IT
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
GB
alies and malfunctions which might occur during
use.
DE
Faults
Smell of gas
FR
ES
The flame is yellow
The appliance does not heat
up
English
TROUBLESHOOTING
Occasional leak because flame
Burner dirty, heat exchange pipes
clogged, condensation drips

FAULT

The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
has gone out
- 14 -
IDM-39603803100.tif
Remedies
Turn off the gas supply tap and
ventilate the room
Important
Contact the after-sales
service
Check the condition of the
thermostat and activate any
ignition enabling device
0°
90°
6