Camera Settings - miniland baby digimonitor 3.5 touch Manual De Instrucciones

WARNING: all device settings are restored to their factory parameters

5.2.6.8.2. CAMERA SETTINGS

You can configure the settings of each camera by accessing the relevant
· Temperature alarm
With this option you can set the temperature display in ºC or ºF and set an alarm that will
alert you when the temperature in the baby's room is outside the set range.
To set the alarm, first select the maximum and minimum temperatura of the range and click
on the icon , which allows you to enable or disable the alarm.
You can also select how long the monitor will emit the alarm signal, from the options
available, by clicking on the icon
· Transmission power/Volume
With this menu you can set the volume level at which the parents' voice is played in the
camera, by using the two-way function. You can choose from 10 levels (0-9) by pressing
the + or – signs as required.
Moreover, from this menu you can change the power level emitted by the camera, by
choosing between the high/low options. When placed in the HI (HIGH) position, it covers a
distance 300 metros in open country with the original power. When place in the LOW
position, the maximum distance is reduced to approximately 150 metres in open country
and the output power is reduced.
You can also control this feature from the home screen (o). Click on the icon (c) and this
will appear next to the power level emitted (LO, HI). Changes made directly on the home
screen (o) only affect the camera that is picking up the images displayed.
5.3. TROUBLESHOOTING
Problem
No reception on
the monitor
.
Possible Cause
Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is
not plugged in or the battery is
low (check LED)
The VOX mode or the MD
mode are active
Monitor out or range
Connection lost between the
monitor and a camera already
linked
icon.
Solution
Press and hold down button
(II) for 2 seconds
Press and hold down the
power button (6)
Plug in the power adapter
Plug in the power adapter or
charge the battery
To see the monitored area
continuously, disconnect the
VOX or MD mode on the
monitor.
Move the monitor closer
to the camera
Link the camera with the
monitor again