Start-Up - KPS PowerCompact3020 Manual De Usuario

4. START-UP

Make sure the electrical cabinet is off before connecting the instrument. Only when the connection is
Switch on the instrument by pressing and holding down the POWER key for approximately 3
seconds (the same action switches off the instrument).
At start-up, the following screen will be displayed for a few seconds where following data are shown:
Error can be shown if one or more probes are missing or are different in a three-phase connection.
complete and safety set, switch on the electrical cabinet.
product;
firmware version;
serial number of the instrument.
A few seconds later it will show the page with the automatic detection of
current probes. PowerCompact3020 is able to detect which current clamps
are connected to its inputs and to configure itself accordingly, storing such
data in the appropriate setup.
If the detection is consistent, after about 20 seconds, or in the case where
the user presses the button
on first page of voltage menu.
Conversely, if inconsistencies are detected, PowerCompact3020 will stop,
showing the message "Clamps error".
, the instrument will automatically position
- 64 -