Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The user can always skip this check by pressing the button
voltage menu and subsequently accessing the setup menu of the amperometric clamps, to perform manual
configuration required.
Once completed the start-up and the clamp settings, system will move to the page of voltages.
5. SETUP
5.1. Main setup menu
Press
for approximately 3 seconds to access the setup menu:
Use
and
keys to select the proper section and press
menu, press
from the main section page.
To exit from the setup, press again
5.2. Parameter setting
When entered into desired section, parameters can be browsed and edited using following main keys:
Use
and
keys to select the parameter to be configured.
Press
and the cursor will start to flash. Use
Press
again to confirm the value. The cursor will stop flashing.
Press
from the main section page to return to the setup menu
to acces it. To return to the main setup
for approximately 3 seconds.
and
- 65 -
and directly accessing the landing page of
keys to modify the selected value.
Publicidad
Capítulos
Tabla de contenido
