Auxiliary Channel Snapshot Function; Snapshot Function; En 50160 Menu - KPS PowerCompact3020 Manual De Usuario

Neutral current waveform and relevant RMS value (only in three-pase and two-phase
connections).
6.2.6.2. Auxiliary channel
On any of the Waveforms Menu pages, press
tracing page. In the AUX Menu, the user can also access the other Auxiliary
Channel Menus (Voltages, Currents, Power, Counters, Harmonics) by selecting
them with the relevant function keys.
Press to exit the Auxiliary Menu and return to the first page of the relevant menu.

6.2.7. Snapshot function

6.2.8 - EN 50160 menu

This menu allows the user to monitor main power quality parameters.
The first page displays the outcome of the EN50160 compliance test (Reference
Standard for power quality), according to the parameters selected in the Setup Menu.
A test is performed to check whether frequency, voltage, harmonic voltage distortion,
and unbalance comply with the above-mentioned reference Standard and the nominal
values which have been set.
A table also shows the number of interruptions, dips and swells which have occurred
during the period monitored.
to access the auxiliary channel
During measurements, press the
immediately (not only those currently displayed). By doing so, the
measurements will remain "frozen" on screen until the same key is
pressed again.
After blocking the measurements, all other menus can be scrolled
through to check the status of the other parameters captured at the
same time.
The word STOP appears on the bottom bar to indicate that
measurements have been blocked.
NOTE: Blocking not only interrupts what appears on the display, but
also the entire measurement process. This means that the data during
the block will not be recorded.
- 89 -
key to block all measurements