Three-Phase Or Two Phase Connection Single-Phase Connection - KPS PowerCompact3020 Manual De Usuario

Load peaks and relevant PF, i.e. the highest average power (calculated on the basis of
the integration time set. Values can be reset).
If Grid Type is set to UPS 3-3 or UPS 3-1 the efficiency page will be shown reporting
following realtime values:
6.2.3.2. Single-phase connection
This page displays active, reactive and apparent power, and the PF (including a note
whether the latter is inductive or capacitive).
NOTE: As a norm:
Average power and PF (calculated on the basis of the integration time set. Values can
be reset).
Minimum instant values of power and PF (values can be reset).
Pin: instantaneous power entering the UPS
Pout: instantaneous power exiting from UPS
Ntot: efficiency of UPS system
Active power and the PF are shown as a negative when generated and a
positive when absorbed.
Reactive power is shown as a negative when capacitive and a positive when
inductive.
- 79 -